Normally, when I start a project, I use prototyping boards to mount the components and develop the software. When the project is finish, I always have the same trouble: in witch box or enclosure I put the electronics? If you don’t have this in mind at the start of the project, it could be a serious problem. In these years, I discover that is more easy to first find and enclosure and then develop the electronics that do it backwards. Also, I usually develop systems for both indoor / outdoor, so protection against rain and humidity usually it’s a must. For these reasons, I decide to find a good enclosure and develop a prototyping board to use with it. In this post you’ll see the results!
Prototyping Board to use with IP55 box
2 respuestas
